KWJ700 Kitchen Woktop Jig 700mm
The Trend KWJ700 KWJ700 Kitchen Worktop Jig, an all in one jig for joining worktops The Trend KWJ700 Kitchen Worktop Jig is a hard-wearing solid laminate, 12mm thick jig that cuts both parts of the joint in 15 minutes including setting up. Trade all in one jig for joining worktops up to 700mm wide with a router. Features: Pins made from ABS plastic for strength Engraved markings for identification of pinholes Engraved lines for short 65mm bolts and worktop cross-cut Three open-ended bolt recesses (dog bone style) for 150mm bolts Cuts up to 40mm thick worktops with or without anti-drip postformed edge Fixed lengths for 250mm, 300mm, 400mm, 500mm, 550mm, 600mm, 616mm, 650mm and 700mm wide worktops 10mm diameter plastic pins with tapered shoulder for tight fit provides three-point pin contact to ensure ease of setting up Left hand and right-hand corners, 400mm radius peninsular joint, 45-degree end cut with slight radius, 45-degree trade corner solution for hob units, 100mm radius corner, 40mm radius corner, 35mm kitchen door hole and 3/4inch BSP hole for mixer taps 9 Functions: Male cut Female cut 45 end cut Curved peninsular R40mm corner radius 45 mitre corner joint Connector bolt recess R100mm corner radius 35mm circular hinge and 3/4" BSP hole Comes with: 6 x ABS Plastic Pins Jig requires: Two clamps A template guide bush with 30mm outside diameter A TCT router cutter with 12.7mm (1/2 inch) diameter and 50mm (2 inch) cut length A portable plunge router with 12.7mm (1/2 inch) shank capacity and minimum 1300 watts Specification: Weight: 5.4 kg Width: 390mm Length: 985mm Thickness: 12mm End Cut: 45 degrees Corner Radius: 40mm Corner Radius: 400mm Corner Radius: 100mm Corner Mitre Joint: 45 degrees Female cut material width loss: 35mm